Incredibly simple and very effective heating unit for the swimming pool can make every one of you in almost any radiator with any brand of car.
All going for 20-30 minutes without any problems. All components can be found in your garage or in a landfill.
- The old radiator of the cooling system of the car. You can buy the “disassembly” or “flea market”.
- The old 200 liter drum.
- Rubber tubes are taken from the same radiator.
All other parts: pump, hoses – supplied with swimming pool.
The heater device and principle of operation
The very Foundation of the heating boiler is at the bottom of the 200 litre drums. That is 2/3 of the barrel cut off top and cut a window for the chamber.
Top without fasteners installed radiator. Him via regular pieces of pipes to connect the hoses. In fact instead of the standard filter element pool are included the radiator.
The pump takes water from the pool and delivers it to the radiator.
With radiator water splashed out back, but warmed.
In a furnace the fire gets divorced, which in turn heats the radiator.
The efficiency of the installation is very high, heat loss is just the minimum. And if you put on the radiator arm, the outgoing heat from the fire did not even burn, because all the heat takes the cooler and gives to the pool.
Ultimately, such a huge tank installation heats up in just two hours! This is a very good time for such a capacity.
For example, if you heat all the water electric coil power of 2 kW, the time to achieve the same result will take almost 10 hours in place of two.