When carrying out summer holiday in the garden very nice to have on the plot a private pool. At first glance, to construct such a structure is expensive and requires months of manual labor. In fact, to make a big pool with their hands in 1 day, almost at the same not spend.
- any Board;
- plywood, OSB, fiberboard, MDF or other sheet material in any state;
- dense plastic film for greenhouses;
- crop packaging film, corrugated cardboard or the substrate under the laminate;
- nails or screws;
The swimming pool construction process
Choosing a place for the pool you need to clean it from weeds, stones and other protuberances. The construction site is cleaned with a shovel and leveled the plane.
Then around the perimeter of the exposed pallets to form the sides of the pool. Built out of them a bowl 2×3 pan you can get a pool with a capacity of 9.5 cubic meters of water.
On top of the pallets stuffed cutting Board to splice them together.
After that, they obryvayutsya outside any existing lumber can be used unedged Board. Solid sheathing is not required, you just need to give the structure sufficient rigidity to bursting with masses of water.
Inside the frame of the pool is sheathed with any sheet material. This is necessary in order to laid in the future, the film is not broken. Parallel to the bottom of the spiked sand.
If the inner lining is made of rough-cuts, to smooth out their edges, it is necessary to unjam the substrate under the laminate or the packaging bubble wrap. You can use corrugated cardboard from boxes. If the bottom of the pool is also laid on cardboard, it is desirable to lay a thin film or an old plastic tablecloth to keep damp, and it has not ate the ants.
Next you need to prepare tape for sealing the frame. Used the usual cheap plastic film for greenhouses. Under the frame with the sides of the 2×3 pan you need to take 2 film cut 3×7 m and solder them together. For soldering they are placed with an overlap of 15-20 cm and prokleivayutsya iron through the newspaper. From this, the polyethylene will melt and boil together. Then the film is placed in the bowl of the pool.
Immediately you need to enable the pump for pumping of water, as it will be drawn longer than the construction itself of the bowl. Parallel to this outer side can be the sheathing frame color film to protect boards from moisture and to make the pool more representative. It leans to the side of the ladder. As a result of 10 pallets turns the bowl 2,4×3,3×1,2 m, which allows guests to swim multiple people at the same time.