In this review we tell you how to make hand baking soil rotary type. The holiday season is in full swing, and homemade is very useful by the way.
The author carves the pattern of the disc cultivator, which has 8 blades. The template can be done from sheet metal, and paper (cardboard).
You may also be interested to read: how to make a metal frame for hammock. In this design it is possible to change the angle of the stands at their own discretion.
Next, cut off five metal plates 15×15 cm add them together then drill the center hole with a diameter of 10 mm.
Fasten on top of the previously cut template (in this case, the master used an aluminum plate), and tighten all bolt with nut. Don’t forget the washer.
Then drill holes between the petals (for convenience) and cut out discs using the grinder. Remove the burrs.
In the next stage, cut two metal plates and bend them at an angle of 90 degrees. Then set the plate at a distance of 18 cm from each other, and weld. In the result, we get the holder.
The holder is a welded mount for the wooden handle. In the lower part it is necessary to drill two holes for the installation axis.
On the axle, put on the prepared disks (with sharpened blades), and between the discs and the wear sleeve. Also mounted on the bolts the bracket is U-shaped, and to it — cutting knife.
Read more about how to make the hand cultivator of the soil, you can see in the video below. This review was prepared based on the author’s YouTube video channel “Caduceus Trismegista“.