DIY

Homemade cart for welding machine

The first thing decided to cook after purchasing his first svarochnik, so this truck for him. Cooked first time in my life, gradually in the process mastered.

Самодельная тележка для сварочного полуавтомата

Hello!

The first thing decided to cook after purchasing his first svarochnik, so this truck for him.

Lower frame and a vertical base of 40×40, the strut and the shelf for the apparatus of 40×20, from the same profile holder cylinder. The upper shelf of 20×20. The lower frame bottom is reinforced with longitudinal 20×20, which rests on the bottom shelf. The grille under the tank from the corner 30.

Cooked first time in my life, gradually in the process mastered.

Самодельная тележка для сварочного полуавтомата

Painted enamel hammer mill Dali. Installed wheels.

Самодельная тележка для сварочного полуавтомата

Installed the sockets, one below the unit itself, and the other by LBM or PSHM or drill or do anything. More outlets decided not to do so as not to create a mess of wires. Use in the garage, sockets around a lot, the is still not one place to pull.

Самодельная тележка для сварочного полуавтомата

The mount for the wire. Just in case added the heat shrink clamps.

Самодельная тележка для сварочного полуавтомата

Fixed the wire.

Самодельная тележка для сварочного полуавтомата

16 shelves from plywood impregnated protection “Aquatex extra”. Screwing did not, just adjusted the size so closely invested in the frame, scored a mallet.

Самодельная тележка для сварочного полуавтомата

Rubber mats and gaskets.

Самодельная тележка для сварочного полуавтомата

Самодельная тележка для сварочного полуавтомата

Holder balloon is also glued with rubber gaskets.

Loop holder made of M8 nuts.

Самодельная тележка для сварочного полуавтомата

After mounting, cylinder, welding machine, laying of the power supply cord and gas supply hose set top shelf from 10 plywood, also screwed, can be removed for easier access to the wiring if necessary.

Shelf size is small to not interfere with opening the machine to replace the wire. The size is chosen such that if you move the camera forward, in exactly enough for opening.

Самодельная тележка для сварочного полуавтомата

Storage provided hooks for hoses and ground wire, were riveted threaded rivets.

Самодельная тележка для сварочного полуавтомата

The arrangement of hooks picked up so that the crocodile mass lay on a shelf.

Самодельная тележка для сварочного полуавтомата

The tank clamp is attached and screw-thumb, convenient and reliable.

Самодельная тележка для сварочного полуавтомата

Built-in extension cable is also wound on the hooks.

Самодельная тележка для сварочного полуавтомата

The mask was most convenient to store directly into the cylinder.

Самодельная тележка для сварочного полуавтомата

Made this truck even in the winter, decided to write only now, when it is used and can confidently talk about how good design. Of the additions since then have only added a Bicycle grip on the handle (the grips) cart (sorry for taftologiyu). In General, the design fully satisfied.

Source:

eurosamodelki.ru

Show More

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button
Close

Please disable your ad blocker

We know you are here for the stories. Not the ads. But we need the ads to keep the lights on. So please whitelist Buzzon.live.