DIY

How to make a simple folding boat for fishing

Going fishing in a small swamp and swim in reeds on a conventional inflatable boats, there is always a high probability to swim back without her. Cylinders inflatable boats are pierced and cut to form at the moment, so swim ordered them into the bushes. In order to safely fish in the dense reeds, you can make a folding boat of the transfer belt.

Как сделать простую складную лодку для рыбалки

Materials:

  • conveyor transfer belt;
  • Board 20х300 mm;
  • plywood 10 mm;
  • rake 10×10 mm.
  • nails.

The process of making boats

Design collapsible boat involves a wooden Board from the Board 20х300 mm.

Как сделать простую складную лодку для рыбалки

Как сделать простую складную лодку для рыбалки

For their manufacturing it is necessary to prostragivat angles 2 boards one edge to be rounded. Round doing the same all round as fore and aft in the boat will not. Due to this, she can sail to any of the parties without the need for reversal. At the bottom of the sides nailed the transfer belt. Between the sides inserted 2 spacers out of plywood, and the top is placed the seat. The design is very simple to manufacture, and in stowing the struts allows you to fold the sides on the tape, significantly reducing the size of the boat.

Как сделать простую складную лодку для рыбалки

The side of the boat are made of arbitrary length, starting from their own preferences and length of existing conveyor belt.

Как сделать простую складную лодку для рыбалки

To protect from rotting they should be impregnated with hot linseed oil. Next you need to dissolve the tape, as initially it is too thick, and the boat with her will not bend.

To dissolve the tape, requires a sharp knife to cut it from the end of one of the layers. It is shared across the entire width at a depth of about 5 cm and Then, at regular intervals, it is perforated. Then loose the edge you need to compress. For that, each of them is installed 2 strip steel with the same holes, and the tape is compressed between them by the bolts. Then hooking one end over a tree or a pole, you need to pull the second tractor or car. In the result of the tension of the tape will bloom.

Obtained thin ribbon is nailed to prosrochennym edges of the boards. Side of it with an outdoor cord must be inside the boat. Nail short nails very often. Due to the elasticity of the tape the adjunction will turn out dense and will not allow leaks.

After fixing the ribbon you want to install the spacers. On the sides of the slats are made under these constraints. Enough 2 plywood spacers. Then render the seat, and installed oarlocks with oars. This boat is in storage in a dry place will last without repair for decades and never fail on the water.

Boat folded:

Как сделать простую складную лодку для рыбалки

Shipping:

Как сделать простую складную лодку для рыбалки

Going for a couple of minutes.

Как сделать простую складную лодку для рыбалки

Как сделать простую складную лодку для рыбалки

Ready to use.

Как сделать простую складную лодку для рыбалки

Как сделать простую складную лодку для рыбалки

Как сделать простую складную лодку для рыбалки

Watch the video

Source:

sdelaysam-svoimirukami.ru

Show More

Related Articles

Leave a Reply

Your email address will not be published. Required fields are marked *

Back to top button

Please disable your ad blocker

We know you are here for the stories. Not the ads. But we need the ads to keep the lights on. So please whitelist Buzzon.live.