To remove pits from cherries or cherries, you can make a homemade device from a disposable syringe. It is simple to manufacture, but it works very effectively. With it, you will be able to process a higher amount of fruit than by hand.
- syringe of 20 CC;
- elastic band for money.
The process of manufacturing the device
He pulled out of the cylinder of the syringe piston, it is necessary to cut the tip.
Then at the end near the remote tip, reams the hole.
It should be slightly larger than the diameter of the pits of cherries or cherries.
Then the side of the cylinder of the syringe is cut out the window for planting berries. It is convenient to do mounting or with a utility knife.
It is cut from the bottom of the cylinder to the mark 6 CC, the Width of the window should allow to lay off, but without a significant reserve, as excessive cut-off wall will reduce the structural strength.
From the stem of the syringe is withdrawn the rubber piston. Next you need to trim the plastic lugs of the piston.
Then until about the mid-rib stem is partially cut along. And two opposite transverse slice is at an acute angle.
From unmounted rubber piston cut with a hole diameter of the narrow part of the cut down stock.
He must enter through not clinging. Then the piston is pressed into the syringe barrel above the cut out window. It will serve as a guide. When installing stock it is important to freely pass through the piston.
Next you need to have a rubber ring on the syringe barrel for stops for the fingers so as to leave 2 loops. They have to cling to previously made on stock ledges. Thus, if the press rod, and then let go, it will come back through the gum.
The band will take the piston back after releasing the finger.
Putting the syringe berry, and pressing the stock, can be accurately, quickly and without a splash of juice to squeeze from it a bone. This is done by pressing the thumb. Immediately after that, the band will return to stock, and berry without the seeds will fall out.
For the manufacture of such a device will take 20 minutes, if the berries a lot, it can reduce the processing of cherry or black cherry for a couple of hours. The plastic syringe is absolutely chemically neutral, so it can safely contact with food. After working with the device for 2-3 minutes, you can practice the movement until it becomes automatic and start to process the cherries with conveyor speed.
Watch the video