In this review, the wizard will show you how to do for the home Studio spindle slipstones. Need it for sanding the edges of workpieces of wood or plywood.
The main working body of the machine is a wooden casing with a wound on her sanding belt. Sleeve simultaneously performs rotational (around its axis) and oscillatory (up and down) movement.
You may also be interested in another useful homemade belt sanding stanochek, made of an electric motor from a washing machine.
First of all block, you will need to carve a wooden casing. This can be done on a homemade lathe or using improvised devices.
Further from the boards sawn off four blanks and drill holes in them. Insert the bearings.
On the next stage out of plywood and two boards assemble the housing for the electric motor. To him fasten the workpiece with the bearings.
They will insert metal rods (rails) — it will move the body to the engine.
The motor is installed inside the assembled hull. The bearings are inserted in the guides. The ends of the guides put on prepared Board.
After that fasten the housing to the sheet of plywood. Also from sections of profile pipes, the author produces a hinge mechanism that will provide the oscillatory movement of the housing to the engine. To the base fasten the side walls.
Assemble the actuator (engine and gearbox), combine it with the mechanism of potrubi and attached to one of the walls.
Wound on the sleeve sandpaper (sanding belt), then fix it on the motor shaft. Fasten the countertop.
The last stage will only establish a connection for dust extraction (you can make it from a piece of plastic pipe), and you can set to work polishing of workpieces.
Read more about how to make a spindle slipstones their hands, look at the video below. The review is based on the YouTube video channel DIY Tools.