If you need to water the beds or seedlings from a garden hose need to use the spray. Without it, the water jet gets close, so you have to come close to each plant, in addition, it erodes the soil and can destroy young shoots. Atomizer to be sure, but if not, then it can be made from a plastic bottle.
- plastic bottle;
The process of making spray
From PET bottles is finally part of the neck with thread. RES runs in front of the stiffener.
Next you need to make a couple dozen small holes in the bottle lid. You can use the heated awl over the flame. Burnout the opening is smoother than drilled.
You then need to paste the cut of the neckline to the edge of the garden hose. The place of gluing the hose is cleaned to roughness.
It is applied hot melt glue, and the top of the stretched neck. For reliability you should also glue the joint on the inside.
Hot melt glue holds well enough to prevent water from leaking at the junction and was sprayed on a fine jet strictly through the holes in the lid. In fact, in functional terms, it turns out the same atomizer that purchase.