Began the season starts, but often happens that the fish swallows the hook too deep, and to get it out without damaging the fish, is very problematic. Here can help the extractor device to extract the hook without harming the fish.
What we need:
- Aluminum wire.
- Wooden handle.
Manufacturer of extractor:
Start with straightening wire, if required. Hold the wire in the Chuck of a drill or screw gun, pressed it to the table by the bar, turn on the drill and try to make it more or less smooth.
Further, if the wire has insulation, remove it with a knife. Get a clean and smooth metallic bar.
With a hammer or vise replusive one of the ends of the wire to a thickness of 1-2 mm.
With a file or needle file make a slit in the shape of the letter “V” . The work with the metal part over.
Start the manufacture of the handle. From cutting the sawn off piece comfortable for you long, I cut off about 10 inches.
Mark the center and drill a hole the same diameter as the wire and a depth of 5-6 inches.
Remove all chipped and uneven rough sandpaper, a smaller round handle and give it an appearance of finished product. Pour superglue into the hole and connect both parts together. And we get ready tool for fishing. Optionally, you can cover the handle with varnish or impregnated with oil.
Such an extractor can be done in 15 minutes in the garage out of scrap materials. It is very light and does not sink in water, which is very important for fishing.