If the grinder has a stout body which is uncomfortable to hold in the hand, it is possible to lengthen a wooden handle. This modified tool will be much easier to hold than the original.
- piece of wood under the handle;
- thin sheet metal;
- clamps with worm clamp – 2 PCs.;
- screws for wood.
The process of making and installing the handle
Their tree to whittle a handle for installation on the side of the hull grinder. It can be made from timber or wood. Its shape should resemble the hilt of his knife.
Giving the handle a convenient form, it is necessary to drill from the end to the diameter of the power cord.
From the body of the grinder removed the back cover and disconnected the plug wire.
You need to make it through a homemade handle, then removed cover and back tie to clemam.
Sheet, cut 2 strips, and bolted to the handle with screws top and bottom.
Shot the cover is installed back onto the body of the grinder.
Then a short screw to it is screwed onto the handle. Next she is fixed on the housing grinders for band two clamps.
The result is that the handle gets quite rigid fixation, and the tool can be used for the purpose.