Greetings to all DIY and those who just stopped by to visit Mr. fix-it. I’m sure many of you, but what can I say, all of you as a child ever built a tent, and built it, where it was possible and what was at hand. In the course went sticks, branches, boards, in General, anything that catches the eye. This child’s play relevant today, is often seen as guys, especially during the summer holidays in the villages, make the various buildings. That’s why we want to offer you one variant of this design. The author has built in the backyard of his lot for their children. Looking in front of say in the house-hut, which he did, and the children can play and adults where you can relax. So, don’t waste time, get started.
Step one – site preparation and manufacture of the frame.
Before you begin construction, the author has prepared the stage. Cleared the area and covered with fine gravel, which is then flattened. Once the site was ready, the author of the timber mounted the frame is A-shaped, so is usually harvested for a swing.
Dimensions the author has picked up considering the fact that the children (he has two of them) in the finished building was convenient and not crowded, as in a tent will be set furniture. To connect the parts of the framework the author used long screws that are screwed into the screwdriver.
Step two – the beginning of the plating.
The rays frame the author was fastened with screws horizontal slats, one side, two on the bottom and one stepping back from the top approximately 100 cm, and the other four, thus dividing the side into three equal sectors. In this way, the author began covering the metal corrugated sheet.
Step three – trim, continued.
Step four – trimming the Gables.
After one side was sewn corrugated sheet, the author moved to the Gables. He closed the OSB boards, pre-drank of them a jigsaw of triangular parts of the right size. In one gable is the author of the carved doorway, and the opposite will cut the window.
Step five – continue to work with Gables.
Step six – the fourth wall – lifting.
The second side wall, the author decided to make transparent and lifting. From a bar the author has collected on the screws, the frame of such size that it is closely placed between the upper and lower rails on the frame. On the frame, using brackets, secured by bolts corrugated polycarbonate. During the fixing of polycarbonate, fixed the handle to raise the wall. The finished frame is attached to the upper crossbar on the door hinges.
The connection details frame in the corners of the reinforced bars.
Step seven – the fastener support stands.
Since the wall lifting must be locking in the open position (at the top). For this purpose the author has made of two timber stands desired length. And installed on the edges of the frame, securing bolts.
Step eight – dobrivka.
As I wrote earlier, with a polycarbonate frame placed between the upper and lower rails. Between the upper rail and the skate is space. The author closed it cut the OSB boards and secured on a solar battery. Looking ahead to say that her energy is used for lighting the tent.
Step nine – finishing.
At this stage the author has placed within the sofa and a hammock. Also held inside the wire from the solar panel and connect them to two batteries which are connected to an led strip.
That’s all. Those who read to the end, I recommend to watch the video review of the author on what happened in the end.
Thank you all for your attention, good luck and see you in the DIY!!!