Need to drill a hole at the right angle, but no drill? In this situation, you can use an alternative stand for the drill.
Consider the easiest option that you can do quick and dirty -literally within 30-40 minutes.
For making homemade’ll need a bit of metal and wooden bars. As base you can use plywood.
You may also be interested in another homemade clip of plywood for gluing of workpieces at a right angle.
First cut a piece of rectangular shaped tube. In the middle of the cut with a grinder the part of the wall. Then do the layout, drill the preset holes.
Sawn off wooden block. Fasten thereto a previously prepared billet of stainless steel.
Profile of the pipe (where was cut out of the wall) to insert the metal strip with a groove. Fix it with screw, but not too much, to piece of work could move along the strip.
Saw off another billet of wood. Bolted it to the metal strip, pre-drilled in it two holes.
Next, cut the plywood base and fasten it to the rack.
In the first block of drilling a hole and make a seat for bearings. Insert the shaft on the end of which screw-on drill Chuck.
The shank of the shaft inserted into the Chuck of a drill. And in the end will only have to drill a hole in the base.
This review was prepared based on the author’s YouTube video channel ideas corner.