The engine from a broken battery power tool can be used for making mini cleaner, which is useful for cleaning the car. It’s very light, quick to clean, besides help out when assembling the scattered details.
- high-speed motor 12V – http://ali.pub/3xhgtm
- a cooler from the computer (can be broken);
- plastic bottles 2 l;
- stocking or sock;
- the plug of cigarette lighter;
- corrugated hose 20-25 mm
The manufacturing process of the vacuum cleaner
From the cooler, removed the blades, then the sky is pressed onto the shaft. If he doesn’t, then it should heat the soldering iron and pull on the hot.
Then the blades must be mounted on the existing shaft of the motor so that the blow-out was sent to the motor housing.
Two plastic bottles cut off the bottoms.
One at the very bottom of the line of stamping, and the other approximately in the middle above. The bottoms of bore holes for diameter of the motor casing. If no crowns, they can be melted through a heated pipe.
The motor is inserted into the long bottom of the blades inside and podklyuchaetsya with hot.
Then it is worn on the outside lower bottom and is fixed also with glue. Also, the adhesive is filled in the seam between the walls of the bottles.
From a plastic bottle with a long neck the neck is cut, and it bore little holes with the soldering iron.
The same holes are burned in its cap. Then you need to make wide openings in the bottoms glued to through them freely out in the pressurized fan air.
The neck with perforation must be inserted in the remaining low after cutting the bottom half of the bottle. Then they are inserted into the engine cover.
To make the handle of the vacuum can be cut off another long neck bottle. It cut the shoulders on it is glued by adhesive to the housing of the assembled vacuum cleaner. It turns out the likeness of a Hairdryer.
In the lid of the spout is cut a cleaner hole and it is inserted into the corrugated hose.
You also need to connect the power cord. To do this, twist the lid with the handle of a vacuum cleaner, and is drilled through it is put cable. Then it should tied a knot so he would not escape, and bring the remaining tail of the wire through the side hole in the handle. Further, the end of the cord is soldered to the contacts of the motor. On the second edges of the wire set the plug under the cigarette lighter.
As such, the vacuum cleaner can be used to collect the scattered details, for example, seeds, bulbs, sawdust, shavings.
If you want to collect dust, the interior the neck with small perforations is stretched a stocking or sock.