Greetings to all fans of homemade products and those who just looked at the site. Today I want to present you with an idea with which your housewives can put things in order in kitchen cabinets and drawers, and solve once and for all, the problem of storing rolls of food paper, foil and baking sleeves. A locker door holder is what you need. The idea in the trailer is not new, there are plenty of them on the Internet, but this one is very simple. Take note of it and please your hostesses. Moreover, the manufacture of such a structure does not take much time, does not require the use of any special tools, and materials can be found by digging in the workshop or, in extreme cases, by walking through hardware stores.
For the manufacture, the author needed two planks and a metal grill. Personally, it reminds me of a shelf from an old Soviet refrigerator, I think something similar, it won't be difficult to find. The author has this detail on one long side with a side, which will be useful in the future, why, you will understand later. The width of the slats should be slightly larger than the width (thickness) of the roll packs that you plan to store in the future holder. Before production, the author measured the width and height of the cabinet door, on which he planned to fix the holder. Based on these measurements, the author had to cut the grille a little. You also need to consider how much the holder will protrude. You may need to trim a shelf in your closet. If you have it there. The author's strips were rectangular to make the future holder look more aesthetically pleasing, the author cut off their edges, giving a curly shape.
And so the necessary parts are ready, you can start assembling. Since the author cut the grate a little, there were sticking rods on the sides. It is from these sides that wooden planks will be attached. In order not to bother with the marking of the holes, the author did it simply. I put a plank on the floor, installed a grate on top of it with protruding rods. On the grate, knocked on top with a hammer, grooves appeared on the wood. He drilled a hole through them. I did the same with the second bar. The photo shows that the author selects a drill by caliber, but it is not at all necessary, it is enough just to measure the diameter of the rods and choose the right drill. When the necessary holes were drilled, the author assembled the holder.
The only thing left to do is to attach the ready-made holder to the door. First, the author selected self-tapping screws of the required length. Here it is important to choose the length so that the self-tapping screw does not come out from the back of the door, but is not too short. After the fasteners were selected, the author drilled holes along the edges of the slats and attached the holder to the door with screws. Then he placed all the necessary items in it, here you can see what the side on the grill is for, the contents of the holder rests against it.
If you have a grill without a rim, that's okay, and you don't have to bend it. It is enough to choose a wooden lath of a suitable width, and also fix it on the screws under the holder.
Well, that's actually all, it turned out quickly, simply and practically. Everyone who has read to the end, thank you for your attention. Good luck to everyone and see you again at Samodelkin's !!!!